GHRH analog raises a handful of sensible questions. This page answers them in order, starting with the fundamentals and moving to applications.
This page was last updated on 2026-05-08 and is reviewed periodically as new material appears.
Two related forms circulate in technical discussion under the same family name. The original version carries a drug affinity complex (DAC) that binds covalently to serum albumin after administration, and this linkage substantially extends circulation time. A second form, frequently written as modified GRF(1-29) or CJC-1295 without DAC, lacks that linker and clears much faster. The naming is a frequent source of confusion because the shorthand CJC-1295 can refer to either form depending on the source. Reports sometimes fail to specify which variant was studied.
The peptide backbone includes a D-alanine at position two, which resists cleavage by dipeptidyl peptidase IV, and several other substitutions that reduce degradation. Its molecular weight is roughly 3.4 kDa without the linker and about 3.6 kDa with it. The molecule is water soluble and is normally supplied as a lyophilized powder. Precise sequence and mass values depend on which variant is described, so technical documents usually state the exact form being referenced.
Lyophilised powder is the usual supplied form. The material is hygroscopic, so vials are typically equilibrated to room temperature before opening in order to prevent condensation on the contents. Long-term storage is generally described at minus twenty degrees Celsius or colder, protected from light and moisture. Repeated freeze-thaw cycles are avoided because they promote aggregation and loss of soluble material. A reconstituted solution is considerably less stable than the dry powder and is normally kept refrigerated for short periods only.
Identity and purity are assessed mainly by reversed-phase high-performance liquid chromatography combined with mass spectrometry. The chromatographic separation resolves the target peptide from truncation products and from species carrying oxidised residues, while mass measurement confirms the expected molecular mass. Because the two common variants differ by roughly 280 daltons, a mass determination distinguishes them unambiguously. Purity is often quoted as a percentage of total peak area, although that figure depends on the detection wavelength and the integration method applied.
Reported half-lives differ widely between the two variants and between species. Values for the albumin-binding form are usually expressed in days, while the unconjugated form is measured in minutes to a few hours. Sampling schedules, assay sensitivity, and route of administration all influence the numbers, which limits direct comparison across studies. Whether sustained receptor occupancy produces different downstream effects from pulsatile stimulation remains an open question in the published work. Claims about relative potency should therefore be read alongside the specific study design that produced them.
| Property | Value | Notes |
|---|---|---|
| Molecular weight (no linker) | ~3.37 kDa | Calculated from peptide sequence |
| Molecular weight (with linker) | ~3.65 kDa | Includes albumin-binding moiety |
| Appearance | White to off-white powder | Typically lyophilized |
| Solubility | Soluble in water | Also dissolves in aqueous buffers |
| Common synonyms | Modified GRF(1-29), DAC:GRF | Usage varies by source |
CJC-1295 is a synthetic analogue of growth hormone-releasing hormone, built on the 29-amino-acid GHRH(1-29) fragment. Four substitutions distinguish it from the natural sequence: D-alanine at position 2, glutamine at position 8, alanine at position 15, and leucine at position 27. These changes reduce enzymatic cleavage and extend the peptide's persistence in circulation. The compound is discussed in two forms, one carrying a drug affinity complex and one without it.
The drug affinity complex is a maleimidopropionic acid group attached to a lysine side chain. It reacts with the free thiol of cysteine-34 on circulating albumin, forming a covalent bond. This conjugation keeps the peptide in the bloodstream and shields it from rapid renal filtration and proteolysis. Reported circulation half-lives for the albumin-bound form fall in the range of roughly six to nine days in early human studies.
Binding to GHRH receptors on pituitary somatotroph cells triggers cyclic AMP signaling and stimulates growth hormone synthesis and release. Because the peptide acts upstream of the pituitary, effects are mediated through endogenous growth hormone rather than direct receptor activation in peripheral tissues. Increases in insulin-like growth factor 1 are generally described as a downstream consequence. Most published human exposure data come from small early-stage studies, and the clinical significance of the pharmacokinetic profile remains incompletely characterized.
CJC-1295 is a synthetic peptide belonging to the growth hormone-releasing hormone analog family. It comprises twenty-nine amino acid residues derived from the N-terminal region of natural GHRH. The molecule incorporates several non-natural substitutions that increase resistance to enzymatic degradation. These modifications extend its activity compared with the native hormone fragment. Researchers use it to study pituitary growth hormone secretion in laboratory and clinical settings. This compound is distinct from native GHRH in its stability profile.
Two principal forms appear in the literature and in research supply. One carries a drug affinity complex, a maleimide-based group that forms a covalent bond with circulating albumin. This linkage slows clearance and produces a long-lasting elevation of peptide levels. The other form lacks that group and is often labeled MOD GRF(1-29). It has a much shorter circulation time. Both variants retain the same core receptor-binding sequence. Reported half-lives differ substantially between the two.
=== Substrates === Substrates for RuBisCO are ribulose-1,5-bisphosphate and carbon dioxide (distinct from the "activating" carbon dioxide). RuBisCO also catalyses a reaction of ribulose-1,5-bisphosphate and molecular oxygen (O2) instead of carbon dioxide (CO2). Discriminating between the substrates CO2 and O2 is attributed to the differing interactions of the substrate's quadrupole moments and a high electrostatic field gradient. This gradient is established by the dimer form of the minimally active RuBisCO, which with its two components provides a combination of oppositely charged domains required for the enzyme's interaction with O2 and CO2. These conditions help explain the low turnover rate found in RuBisCO: In order to increase the strength of the electric field necessary for sufficient interaction with the substrates' quadrupole moments, the C- and N- terminal segments of the enzyme must be closed off, allowing the active site to be isolated from the solvent and lowering the dielectric constant. This isolation has a significant entropic cost, and results in the poor turnover rate.
=== Original format === The original FASTA/Pearson format is described in the documentation for the FASTA suite of programs. It can be downloaded with any free distribution of FASTA (see fasta20.doc, fastaVN.doc, or fastaVN.me—where VN is the Version Number). In the original format, a sequence was represented as a series of lines, each of which was no longer than 120 characters and usually did not exceed 80 characters. This probably was to allow for the preallocation of fixed line sizes in software: at the time most users relied on Digital Equipment Corporation (DEC) VT220 (or compatible) terminals which could display 80 or 132 characters per line. Most people preferred the bigger font in 80-character modes and so it became the recommended fashion to use 80 characters or less (often 70) in FASTA lines. Also, the width of a standard printed page is 70 to 80 characters (depending on the font). Hence, 80 characters became the norm. The first line in a FASTA file started either with a ">" (greater-than) symbol or, less frequently, a ";" (semicolon) was taken as a comment. Subsequent lines starting with a semicolon would be ignored by software. Since the only comment used was the first, it quickly became used to hold a summary description of the sequence, often starting with a unique library accession number, and with time it has become commonplace to always use ">" for the first line and to not use ";" comments (which would otherwise be ignored).
in the expansion gives the Navier-Stokes equations, which include terms for viscosity and thermal conductivity. To obtain the Burnett equations, one must retain terms up to second order, corresponding to
Sources: en.wikipedia.org
=== Inherited antithrombin deficiency === The incidence of inherited antithrombin deficiency has been estimated at between 1:2000 and 1:5000 in the normal population, with the first family suffering from inherited antithrombin deficiency being described in 1965. Subsequently, it was proposed that the classification of inherited antithrombin deficiency be designated as either type I or type II, based upon functional and immunochemical antithrombin analyses. Maintenance of an adequate level of antithrombin activity, which is at least 70% that of a normal functional level, is essential to ensure effective inhibition of blood coagulation proteases. Typically as a result of type I or type II antithrombin deficiency, functional antithrombin levels are reduced to below 50% of normal.
== Contraindication for specific diseases == Aminoglycosides can exacerbate weakness in patients with myasthenia gravis, and use is therefore avoided in these patients. Aminoglycosides are contraindicated in patients with mitochondrial diseases as they may result in impaired mtDNA translation, which can lead to irreversible hearing loss, tinnitus, cardiac toxicity, and renal toxicity. However, hearing loss and tinnitus have also been observed in some patients without mitochondrial diseases.
== Inside the body == Hemolysis inside the body can be caused by a large number of medical conditions, including some parasites (e.g., Plasmodium), some autoimmune disorders (e.g., autoimmune haemolytic anaemia), drug-induced hemolytic anemia, atypical hemolytic uremic syndrome (aHUS)), some genetic disorders (e.g., Sickle-cell disease or G6PD deficiency), or blood with too low a solute concentration (hypotonic to cells). Hemolysis can lead to hemoglobinemia due to hemoglobin released into the blood plasma, which plays a significant role in the pathogenesis of sepsis and can lead to increased risk of infection due to its inhibitory effects on the innate immune system.
Sources: en.wikipedia.org
No. It is a synthetic analogue modeled on the first 29 residues of human GHRH. The substitutions and any linker are laboratory modifications rather than features of the endogenous peptide.
Early development used the albumin-binding form, and a shorter variant was later discussed under the same label. Because the two differ in half-life and handling, ambiguity arises whenever a source omits the variant designation.
The compound derives from that fragment but is not identical to it. The parent fragment lacks the stabilizing substitutions, so its degradation rate and duration of action differ noticeably.
Chromatography reports how much material elutes as a single peak but does not confirm what that material is. Mass spectrometry supplies the molecular mass, which is characteristic of a given sequence and its modifications. Together the two methods support both a purity figure and an identity claim.